FILE NAME:	CP015920.scexe

TITLE:		HP Online Firmware Upgrade Utility for 
		Intel adapters on Linux x86_64

VERSION:	1.0.7

REVISION:	0

LANGUAGE:	English

CATEGORY:	Software Solutions

DIVISIONS:	Enterprise and Mainstream Servers

EFFECTIVE DATE:	12/06/2011

SUPERSEDES:	Initial release


Products Affected
==================
HP Ethernet 1Gb 2-port 361i Adapter


Operating Systems
==================
Red Hat Enterprise Linux 6 Update 2 for AMD64/EM64T
Red Hat Enterprise Linux 6 Update 1 for AMD64/EM64T
Red Hat Enterprise Linux 6 for AMD64/EM64T
Red Hat Enterprise Linux 5 Update 7 for AMD64/EM64T
Red Hat Enterprise Linux 5 Update 6 for AMD64/EM64T

SUSE LINUX Enterprise Server 11 Service Pack 1 for AMD64/EM64T
SUSE LINUX Enterprise Server 11 for AMD64/EM64T
SUSE LINUX Enterprise Server 10 Service Pack 4 for AMD64/EM64T
SUSE LINUX Enterprise Server 10 Service Pack 3 for AMD64/EM64T


Pre-requisites
===============
ProLiant server supporting above operating systems
2GB RAM minimum
hp-igb source rpm >= 3.1.16-3


Description
============
This scexe contains the utilities and binaries for upgrading 
Firmware on HP Proliant Intel adapters on server running any
of the supported OS versions above


Enhancements/Fixes
===================
Initial release


Table of Contents
=================
Introduction
Packaging
Performing the Firmware Upgrade
Firmware Upgrade Log


Introduction
============
This file describes the procedure to use for upgrading firmware
on HP network adapters mentioned in the PRODUCTS AFFECTED
section of this document.

User guides and additional HP Network Adapter information can be found at:
http://h18004.www1.hp.com/products/servers/networking/index-nic.html
 
Packaging
=========
This firmware upgrade utility is released in SCEXE format. The
file is a single self-extracting executable that unpacks the
component, runs it, and cleans up. This one-step process replaces
the rpm format which would require three steps to install, execute
and remove.


Performing the Firmware Upgrade
===============================
1. This utility requires the hp-igb KMP to be built and installed 
using the source rpm version >= 3.1.16-3. Refer the text file that
accompanies hp-igb source rpm for instructions to build and install

2. igb driver module must be installed and interfaces recognized

3. Firmware can be upgraded interactively using following command:

	# ./CP00xxxx.scexe

4. The help menu lists all available command line options.

	# ./CP00xxxx.scexe -h


Firmware Upgrade Log
====================
Results of the firmware upgrade are written to bootutil.log which 
gets saved in the current working directory.


Copyright 2011 Hewlett-Packard Development Company, L.P.
Product names mentioned herein may be trademarks and/or registered trademarks
of their respective companies