Node inventory

The node inventory collects information about the node, and the firmware, software, and driver versions installed on the node.


	NOTE: HP SUM uses the same inventory function for all node types.

HP SUM cannot inventory a node if the credentials are not valid. If the credentials are not valid for the node, edit the node credentials. For more information, see Editing a node.


	NOTE: If you perform inventory on an OA node, HP SUM automatically adds and inventories the associated nodes if you select the check box on the Add Nodes screen. Add VC credentials separately. If you perform inventory on other nodes, HP SUM does not find an associated OA until the end of the inventory process. Add credentials to the OA and then perform inventory on the OA node. For more information on associated nodes, see Associated nodes deployment behavior.

From the Nodes screen, highlight the node and then select Actions → Inventory.

NOTE: If a node has a baseline assigned to it, the inventory process begins immediately. The following steps are only required if a baseline needs to be assigned to a node.
HP SUM displays the baseline associated with the node. If you want to reassign the baseline that HP SUM will use for inventory, select a baseline, additional package, or both.
Click Inventory. HP SUM displays errors that you need to resolve before you can deploy updates. For example:
- The node is part of an active Serviceguard cluster.
- The node does not have enough disk space.
- The node is managed by OneView.
- You provide the secondary IP address for a VC node.

prev	up	next
Aborting a node update	home	Deploying a node


	NOTE: If a node has a baseline assigned to it, the inventory process begins immediately. The following steps are only required if a baseline needs to be assigned to a node.